Assembly line track laying using the SVM 1000 I

The SVM 1000 I has been designed for laying new track in particular. The first machine of the SVM series was put into operation in Australia in 1981. Since then, it has since laid thousands of kilometres of track.

Operated highly successfully on four continents, the proven machine concept stands out due to its compact design, ease of use, precise sleeper placement and the high output. Experience has shown that - with a continuous supply of new sleepers and rails - an output of 300 km per year can be expected.

The SVM 1000 I, consisting of one laying unit and two portal units, is built by Plasser India. The machines are equipped with clip units. They are suitable for the transport and laying of sleepers and rails. The portal units are height adjustable allowing compliance with the gauge during transfer travel. For this, the craneway is lowered into the parking position.

The construction train is supplemented with flat cars, 45 of them in the case of GMR Group. These have been adapted for the transport of the sleepers and rails required for track construction. One layer of UIC 60 rails (12 rails of 250 m length) sits below four layers of concrete sleepers of Indian manufacture. As a rule, 24 such cars are coupled to the laying machine with sufficient material for 1.5 km of track, which corresponds approximately to the output of a 6-hour work shift.

New track construction with integral rail placement

Portal units equipped with special gripper arms pull the rails to the front of the machine. Hydraulically adjustable role ensure the correct guidance. At the front, the rails are taken over by a site vehicle with rail grippers and pulled onto the ballast bed over auxiliary rollers. This is how the rails are pre-positioned in defined construction stages.

During work operation, the laying machine is supported on the front transport car. The track-laying truck is used as the drive for the complete train, including the sleeper and rail transport cars. The portal units transport each layer of sleepers to the laying unit. A proven feed system takes them to the laying unit, which lays them at a precise spacing. The laying output achieved during use in India is ten to twelve sleepers per minute.

The pre-positioned rails are lifted again, taken past the machine frame, placed on the newly laid sleepers and fixed using the integrated clip units. The complete material logistics therefore takes place on the track under construction.

The basic machine concept includes an autonomous energy supply. Once operation has started, the SVM 1000 I works continuously. A reference wire serves to guide the machine for accurate laying of the sleepers with regard to lateral alignment and radius.

To complete the track construction work, a Plasser & Theurer MDZ mechanised track maintenance train is available, consisting of a levelling, lifting, lining and tamping machine, a ballast profiling machine and a Dynamic Track Stabiliser.

Plasser & Theurer uses cookies to allow you to use the website as conveniently as possible. By browsing the website, you agree to the use of cookies. For more information on cookies and how to delete them, please see our privacy notice.